CNC turret punch die also known as CNC punch die, usually by the upper mold, the lower mold, mold seat three parts.
There are various types of moulds. Here are only a few special moulds:
1. Porous die
The multi hole die means that one die can punch multiple holes at the same time, and the efficiency can be increased several times for the punching hole plate. When making a porous die, it should be ensured that the * small distance between the holes and the edge of the plate should not be less than twice the thickness of the plate. If the distance is too small, it will cause distortion and deformation of the plate and affect the processing effect. The connection between the holes in the lower die is also easy to break.
2. Shutters and Bridge formwork
The shutters mold and Bridge mold belong to the punching and stretching molding mold, which are commonly used in the cabinet. The figure below shows the schematic diagram of these two kinds of molds.
3. Counterbore die and rib pressing die
The countersunk die and the rib pressing die belong to the extrusion molding mold. The rib pressing die is mainly used to press the small circular groove on the flat surface, which is equal to the reinforcing rib effect of the plate surface, and the processing is simple and beautiful.
Numerical control turret punch die our company's pictures are as follows: